Washer Pull Plug - Long Series -
Ultrabake™ Washer Pull Plugs Long Series are designed to mask plain and threaded holes; they will mask off the hole and leave a circular grounding or earthing area around the hole.
How the product is used
The hole must be a through hole.
The plug is applied by being pulled into the hole. The narrow end of the plug is placed into the hole, and then the operator uses the narrower end to pull the larger end through the hole. As the plug is pulled the larger diameter stretches and becomes smaller, allowing the plug to fit through the hole. Once the grounding diameter is tight against the face of the area to be masked, the plug is released. The plug then forms a tight seal on the hole and the grounding area.
One end of the plug is similar in design to a pull plug, whilst the area above the grounding diameter can be used as a handle to remove the plug.
Powder coating, E-coating, Plating, Anodizing, Spray painting Temperature Range
Maximum temperature 600 ºF (315 ºC) Design Features
|UWPPLS-SH-M4||A N/A .394 in10.01 mm||B N/A 0.140 in3.56 mm||C N/A 0.875 in22.23 mm||D N/A 1.000 in25.400 mm||E N/A 0.520 in13.21 mm||F N/A 0.190 in4.83 mm||Colour N/A Blue||Packaging -Bag N/A 250|
|UWPPLS-SH-500||A N/A 0.500 in12.700 mm||B N/A 0.167 in4.24 mm||C N/A 1.125 in28.58 mm||D N/A 1.375 in34.93 mm||E N/A 0.600 in15.24 mm||F N/A 0.225 in5.72 mm||Colour N/A Green||Packaging -Bag N/A 250|
|UWPPLS-SH-562||A N/A .562 in14.27 mm||B N/A 0.193 in4.90 mm||C N/A 1.500 in38.10 mm||D N/A 1.250 in31.750 mm||E N/A 0.650 in16.51 mm||F N/A 0.225 in5.72 mm||Colour N/A Black||Packaging -Bag N/A 250|
|UWPPLS-SH-M6||A N/A .591 in15.01 mm||B N/A 0.211 in5.36 mm||C N/A 1.500 in38.10 mm||D N/A 1.750 in44.45 mm||E N/A 0.610 in15.49 mm||F N/A 0.250 in6.35 mm||Colour N/A Rusty Red||Packaging -Bag N/A 250|